How to hack any IR Remote using arduino.
How to hack any IR Remote.
My remote control was not working properly recently, So I decided to make a homemade remote using Arduino. When we push a button on our remote, it sends some code to the device. It does that by rapidly blinking the IR transmitter led on our remote, we can't see the IR Transmitter blink because it is not visible to the human eye. but a camera can catch that blink.
To find out the code that has been sent by the remote, we are going to use an IR receiver with the Arduino. After installing the IR remote library and uploading the IRrecvdemo Sketch, we can see its code in the serial monitor.
Next step would be to write a program and in the If statement of a button, we need to send those code using a send NEC function.
By this method, we can clone any IR remote we want.
Partlist:
Arduino
IR Receiver
IR Transmitter
Switch
1K and 100 Ohm Resistors
Coin Cell Battery Connector
Schematic and Code: https://goo.gl/8R9Rv1
IRremote Library: https://github.com/z3t0/Arduino-IRremote
LowPower: https://github.com/rocketscream/Low-P...
Music By : NoCopyrightSounds
Music Name : Electro-Light - Symbolish[NCD Release]
• Electro-Light - Symbolism | Trap | NC...
? Connect with NCS
Facebook / nocopyrightsounds
Twitch / nocopyrightsounds
Twitter / ncsounds
Spotify http://bit.ly/SpotifyNCS
SoundCloud / nocopyrightsounds
Goo+ http://google.com/+nocopyrightsounds
Instagram / nocopyrightsounds_
