Soldering a Raspberry Pi HAT - Circuit Design in Fritzing
This video goes through the steps involved in taking an electronics circuit and creating a printed circuit board (PCB). In this case this is designed to fit on top of a Raspberry Pi, similar to a Raspberry Pi HAT (although it does not meet the full specification of a HAT).
This is for my Raspberry Pi Christmas House project: • Raspberry Pi Christmas House and NeoP...
My earlier video explains how the breadboard and schematic diagram were creating in Fritzing: • Design an electronics circuit in Frit...
then I created the printed circuit board design in Fritzing: • Design an electronics circuit in Frit...
#RaspberryPi
I've now got the completed printed circuit board back, so this video goes through the steps to solder the components to the board, solder and crimp the LEDs and NeoPixel and to setup the Raspberry Pi.
More information on the Raspberry Pi setup, including the software is available from my website: http://www.penguintutor.com/projects/...
#Maker project #soldering
Chapters:
00:00 Introduction to Designing a circuit in Fritzing
01:23 Printed Circuit Board
03:50 Soldering the resistors to the PCB
06:55 Soldering the MOSFETS to the PCB
08:48 Soldering the male headers to the PCB
10:57 Soldering the terminal connectors
12:30 Solering on the Raspberry Pi GPIO connector
14:01 Checking the Raspberry Pi HAT soldering
14:58 Soldering wires to an LED
20:27 Crimping a female (dupont) connector to the wire
24:39 Wiring up the series LEDs (f-fwd)
25:44 Soldering the RGB addressable LED (NeoPixel)
36:00 Crimping 4-way female connector to the wire (f-fwd)
39:31 Connecting the wires to the PCB connectors
40:17 Installing inside the 3D printed house
43:01 Adding fake snow
44:51 Software download from website
45:35 Running pgzero software
47:30 Complete house
