DVR camera connection Audi A6 C7 to the standard wiring with a fuse
The DVR model is Xiaomi #70mai Dash Cam Pro Plus+ A500S-1 + rear view camera.
To secretly connect and power the DVR from the on-board network on #Audi #A6C7, you will need to buy
1) VAG pin N90732703 for connection in the fuse box
2) fuse rated at 5A and below
3) Cigarette lighter connector
4) ring terminal for cable clamping with a bolt
=====================
Of the tools, you will need end heads for 8 and 10
In order to remove the glove compartment, you need to unscrew three bolts by 8 from the top and two from the bottom.
During the work, I turned off the negative terminal of the battery with the end head 10, do not close the trunk lid at the same time.
To remove the lining of the front rack, first remove the narrow lining in the doorway, then remove the AIRBAG icon, and pull the lining towards yourself, snap off 3 clips along the entire length, after that it needs to be pulled up towards the ceiling.
=====================
I connected it to the block with black fuses, it is powered by 12V only when the ignition is on. If you need constant power, connect it to the beige one.
=====================
For Audi A4 B8, you can do the same, an example of disassembling the fuse block is in this video • Установка bluetooth Audi Concert A4 A...
There is a separate video for the Audi A6 C6 • Подключение регистратора Audi A6 C6 к...
Time codes:
0:00 Start
0:31 What you will need to buy
1:09 What needs to be done
3:42 Removing the glove compartment
4:30 Removing fuse blocks, checking the ACC power supply
6:31 Disconnecting the battery terminal
6:52 Disassembly and connection of the power cable to the fuse box
9:03 Removing the plastic lining of the rack and sill
10:30 As was done by the previous owner
14:51 Removing the front pillar trim
17:03 Connecting the negative contact to the ground
19:30 Laying the cable for the rear camera
=====================
Blog on DRIVE2 https://www.drive2.com/users/mark47/
=====================
