How to remove stump. How to remove stump from sawing
How to remove stump from the tree. How to remove stump from the sawing tree in a simple way. If the cortex is not suitable for any reason, and you also do not have a pedrobile (milling) machine, it remains literally a couple of ways to quickly remove the stumps. The first way is to burn the stump, but in this case there are a number of tricks. In order for the result to be satisfactory, and the process did not turn into a flowless translation of firewood over the nonsense, it is necessary to pre-prepare. First, the top of the stump must be cut off the saw as possible. Then around the perimeter of the stump is drilled by a series of holes with a pen with a diameter of 20-25 mm at a distance of about 10 centimeters from the edge. The depth of the holes should be about 25 cm or more. To do this, you may need a special extension cord and bits. Next, similar holes in the walls of stumps are drilled at an angle of 45 ° at a distance of the same 10 cm from the top edge. Upon completion of the holes filled with kerosene or diesel, after which the stump must be covered with a film and tied with wire or rope. Now you need to wait until the wood is prettier in the kerosene. This process can take from several days to a pair of weeks. In any case, the hurry will be unnecessary here, and it is possible to break the "technology" only if you are very limited in time and want to solve the issue in a more compressed duration. After the wood fully absorbs a flammable liquid, the stump is set up with a lit paper. After the ignition, the stump can smolden for several days, leaving the funnel at the end of the funnel.
