Replacement of transmission mount (CVT) Audi A6 C7 / A4 B8 / A5 / A7 / Q5
Symptoms for replacing the gearbox mount: engine vibration, bumps and kicks when switching gears. I had no such symptoms, but since I recently changed two engine mounts ( • Замена гидравлических опор/подушек дв... ), decided to change the mount of the CVT.
===========================
To replace the rear mount of the gearbox (in my case, the variator 0AW), the following tool will be required: a key for 13, an end head for 13, Spline M10, Spline M12, a torque wrench for 20 Nm and 70 Nm.
===========================
The article of the original VAG silent block 8K0399151DD / 8K0399151DB
I bought a non-original mount PATRON PSE30585
Link to the instructions from ELSA https://disk .yandex.ru/i/0gTB084FT2XU5Q
===========================
Timecodes:
0:00 Start
0:11 ELSA instruction, tightening torques
0:45 Removing engine and gearbox protection
1:05 Removal of the gearbox mount
1:54 Removing the crossbar of the tunnel
3:04 Comparison of the condition of the old mount and the new one
6:14 Installation of a new variator mount
7:42 Tightening torques with a torque wrench
8:23 About the results after replacing the silent block
===========================
My blog on Drive2 https://www.drive2.com/users/mark47/
