Cruise control installation manual Audi A6 C6 (articles, coding VAG-COM)
Detailed instructions for the installation of the cruise control in the #Audi #A6C6 2008.
The cost of the kit is less than $10
Steps:
1) Removing the airbag Torx T30
2) Steering wheel Spline M12
3) Bottom cover Torx T8, T25
4) Ring 5 latches
5) CC Connection Torx T8
6) Bottom panel, head 8
7) Unplug connector under the steering wheel
8) Unplug the "white" connector
9) Connecting the new cable Male-Female
10) Cutting a new hole in the steering wheel housing
11) the problem with the transmission
12) Coding and activation of cruise control via VAG-COM
13) Test race
14) Conclusion
Original cruise control kit VAG 8E0054690
Lower steering column cover WITH the CUTOUT VAG 4F0953512E6PS
Non-original CC Topran 110110755, PATRON P15-0024, OSSCA 01902
Long screws 2pcs VAG N90906802
Male connector BMW 12527512135
Female Connector VAG N90764701
Cable
Coding VAG-COM to connect the cruise control
1) Delete all issues
2) Go to 01-Engine
If you can click "Coding II -11" click and instead of 00000 enter the code 11463 and the save
Else Coding - 07 - «Long coding», select #6 bytes (default 00) and put the very first tick "Bit 0" Cruise Control Installed then the top button "Exit" - «Do It!», "Coding accepted" window should appear»
3) Go to the controller 6 - Steering Wheel - Coding - 07 - change the penultimate digit to 4. (was 0002011 became 0002041) - «Do It!»
This coding is completed to check the operation of the CC need to go on the road and gain speed of at least 30 km/h
Possible problem:
Error 049409 in block 01 - Engine
049409 - No communication with transmission control module U0101-009
Error 01315 in block 03 - ABS Brakes
01315 - Transmission Control Module 004 - No signal / Communication
Solution - poorly connected white connector, you need to make sure that the upper part near the body is connected (the connector consists of two parts)
