Using Subroutines with G70

Опубликовано: 02 Ноябрь 2024
на канале: Practical Machinist

1,378

In this video, Marc, AKA the GCodeTutor, explains how we use subroutines to reuse our tool paths to minimize our code and speed up the programming process.

When we have programmed a roughing cycle, we can either program the same tool path again for our finishing cycle or we can use subroutines to recall that tool path again.
By using a subroutine we can cut down the amount of code that we need to write.

By using P and Q values that match the program number lines. We can recall that section of the program with just one line of code.

If you want any more information about these codes or other G-code information, head to
Website: https://gcodetutor.com/
Facebook:   / gcodetutor
Twitter:   / gcodetutor
YouTube:    / @gcodetutor
Pinterest: https://www.pinterest.co.uk/gcodetuto...