Guide to use Sweep command in autocad - Autocad Tutorial _ Autocad for Beginer and Advancer
Guide to use Sweep command in autocad - Autocad Tutorial _ Autocad for Beginer and Advancer.
Autocad sofware. Hướng dẫn sử dụng autocad, autocad tip.
The following prompts are displayed.
Objects to Sweep
Specifies an object to use as the sweep profile.
Sweep Path
Specifies the sweep path based on the object you select.
Mode
Controls whether the sweep action creates a solid or a surface. Surfaces are swept as either NURBS surfaces or procedural surfaces, depending on the SURFACEMODELINGMODE system variable.
Alignment
Specifies whether the profile is aligned to be normal to the tangent direction of the sweep path.
If the profile is not perpendicular (normal) to the tangent of the start point of the path, then the profile automatically aligns. Enter No at the alignment prompt to prevent this.
Base Point
Specifies a base point for the objects to be swept.
Scale
Specifies a scale factor for a sweep operation. The scale factor is uniformly applied to the objects that are swept from the start to the end of the sweep path.
Reference. Scales the selected objects based on the length you reference by picking points or entering values.
Twist
Sets a twist angle for the objects being swept. The twist angle specifies the amount of rotation along the entire length of the sweep path.
Bank. Specifies whether the curve(s) being swept will naturally bank (rotate) along a 3D sweep path (3D polyline, spline, or helix).
