Lines polyline are non coplanar autocad drawings

Опубликовано: 13 Декабрь 2024
на канале: CAD Designer

17,146

Trying to make a fillet between two line, but a message like this is showing in the command line: Lines or polyline are non coplanar?
soluation is :-
http://www.autocadproblems.com/2015/1...

1- If its poly line :-

Select polyline go to properties' then 'Elevation' then select 0

2- If its line :-
Select line go to to properties then start z or end z put 0

http://www.autocadproblems.com/2015/1...
Issue:
You are trying to TRIM, EXTEND or FILLET two lines in AutoCAD and are receiving an error "Lines are non coplanar" and the lines are not modified.
Causes:
One or more of the line verticies is not at the same elevation as the other verticies.
Solution:
Select all of the lines you are trying to modify
Right click and select Properties
Set Start Z and End Z to 0 or another consistent value - The default may be "Varies"