Make It & Brake It

How to Fix 3D Print Warping and Lifting on a Creality CR-10 [3D Printing Basics Episode 8]

Fixing Stringing in Your 3D Prints (Featuring Creality CR-10) [3D Printing Basics Episode 7]

Cell Phone or Garmin: Which Adventure Motorcycle GPS System is Best?

How to Fix 3D Print Warping and Lifting on a Creality CR-10 [3D Printing Basics Episode 8]

3D Printing Smarter: Tips on Reducing Print Times/Material on Large Prints [3D Printing Basics Ep10]

Fabricating and Welding Custom Engine Crash Bars [Project HyperTenere Episode 21]

Clogged and Bogged: Fixing Filament Clogs in CR-10 Nozzle and Bowden Tube [3D Printing Basics Ep 12]

Truck Bed Coating As Paint? Fiddly Bits on the HyperTenere [Project HyperTenere Episode 24]

Installing New Trail Tech Vapor Dash on the DR-Z400

Yamaha R6 vs. Washington Backcountry Discovery Route (WABDR) Section 1 [Project HyperTenere Ep 31]

How To Upgrade Creality CR-10 w/ Micro Swiss All-Metal Hot End [3D Printing Basics Episode 13]

Fixing Starting Issues, Installing Skid Plate, and other Jank on our DR-Z400 [DRZ Episode 4]

Anisotropic Material: Why Your 3D Prints Break [3D Printing Basics Episode 14]

New Bike for the Channel! Starter Dual Sport Motorcycle and Her First Bike [DRZ-400]

Fitting and Installing Racing Seats in our Project RX-8 Race Car [Doritos Locos Ep 21]

Paint, Wiring, and Front Fairings: Project Yamaha R6 FINISHED(for now) [Project HyperTenere Ep 29]

Tip for making The BIGGEST 3D PRINTS POSSIBLE! [3D Printing Basics Episode 11]

99 Yamaha R6 Adventure Bike Build First Ride [Project HyperTenere Ep 30]

The Dorito LIVES! Welcome Back the Project RX8 Seat Time Build [Doritos Locos Episode 17]

Relocating Coolant Reservoir and Installing Rear Brake Lines [Project HyperTenere Episode 23]

New Foot Pegs and Mounts Installed for our Pivot Pegz! [Project HyperTenere Episode 26]

First Ride/Review of the new DR-Z400 at Tahuya State Forest

How to Remove RX-8 Seats: Race Car Interior Prep [Doritos Locos Ep 18]

Finishing Custom Foot Controls and Bonus Welding Tips [Project HyperTenere Ep. 28]

Mounting LED Lights and Instruments: Fabbing Up Mounts from Scrap [Project HyperTenere Episode 25]

Upgrade Hand Controls: R6 Shorty Vortex Levers & Hand Guards Install [Project HyperTenere Ep 27]

RX8 Interior Removal Part 2: Dash, Door Panels, Trunk, Airbags [Project Doritos Locos Episode 19]

An Adventure with new Adventure Bike: Yamaha R6 on WABDR and Ranier National Park [Funanigans Ep 8]

How To Install NRG Quick Release Hub and Racing Steering Wheel in RX-8 [Project Doritos Locos Ep 20]